Can you jumpstart an EV?

Can you jumpstart an EV?

First thing's first: Find the LV battery, which could be anywhere in the vehicle.

Here’s a real-world scenario: A customer brings their EV into your shop for service, and it’s been there for quite a while because the parts are on backorder. After a few weeks, you get in the vehicle to move it out of your way, and the ignition won’t turn on. It’s acting like the battery is dead, so what do you do now?

Chances are that the low voltage or LV, or 12V, battery inside that EV has gone dead. In most cases, the LV battery is not charged while the high voltage (HV) battery is plugged into the wall charger. So, even if your shop is outfitted with an HV wall charger, the LV battery could still go dead if it’s left alone long enough.

This scenario can present a few unique challenges to us as techs or shop owners. The first question we need to ask ourselves is, “Can I jump this EV with another car?” We would advise against this idea. It’s much safer to have a dedicated battery jumper, preferably one with some electronic assist to protect the system from surges, inverse polarity, etc. Compact battery jump packs are available and are really handy for all kinds of situations.

Now you need to find the LV battery, and it could be anywhere in the vehicle. This of course will vary from one EV to the next, but the most common locations would likely be under the hood or in the trunk. But, herein lies another challenge – some EVs, specifically Teslas, have electronic door poppers which release the trunk and the hood, AKA the front trunk or frunk. So, it sort of turns into a “chicken before the egg” situation. How can you open the hood to get to the LV battery and jump it, if there’s no 12V power to actually open the hood?

Fear not, because Tesla thought this one out. There is a pair of wires that are located just behind the front tow hook cover in the front bumper cover. With a 12V battery jump pack on hand, press firmly on the top right perimeter of the tow hook cover until it pivots inward, then gently pull the raised section out toward you. Pull the two wires out of the tow eye opening and connect them to the jump pack: red positive to red positive, black negative to black negative.

Be aware that these wires are not a charging point for the LV battery. Applying 12V power to these wires will only pop the hood release, but now you can gain access to the LV battery inside. Open the hood and remove the trim panel which covers the LV battery. Locate the positive charge/jump post, and connect a suitable battery charger or jump pack to it. Attach the negative cable from the charger/jump pack to the beam in front of the LV battery. You should now be able to charge or jump the LV battery, and power on the ignition.

You May Also Like

BEV brake service tips

In order to disconnect the 12-volt power system on the Model S you must access the “frunk” or front trunk. And before you disconnect the 12-volt battery you need to do two things.

bendpak-EV-garage

If you are servicing the brakes or suspension system on a Tesla Model S, you do not need fancy orange gloves or insulated tools. The brake system on the vehicle uses the 12-volt electrical system and not the 400-volt electrical system. Still, it is always a good practice to disconnect the 12-volt power system if you must remove a caliper or replace a brake hose.

Grid management at the intersection of hardware and software

We discuss the need for renewable energy generation and the benefits of managing EV charging intelligently at a hyperlocal level.

wallbox-1920-cdk-1400
What you need to know about EV cooling systems

The large batteries that EVs carry need to be maintained within a specific temperature range for optimal performance.

EV-IQ-EV-Cooling-Systems-1400
AMN Drivetime with Epicor’s Jon Owens

Owens describes what he’s learned from volunteering in the industry and his vision for AACF as current its president.

Jon-Owens-AMN-Feb-24
Are EVs really more expensive to maintain?

We speak with CDK Global’s director of content marketing and industry analyst about EV maintenance, EV tax credits and the effect that social networks have on one’s knowledge and interest in EVs.

Amped-CDK-1400

Other Posts

LG Energy Solution’s $5.5B battery facility to be completed by 2026

LG Energy Solution said the cylindrical battery plant, called LG Energy Solution Arizona, will produce 46-Series batteries for EVs.

LGES_Arizona-Construction
StoreDot tests battery cells to perform in cold conditions

Recent tests revealed that StoreDot’s silicon battery cells reach 80% capacity when charged at -10°C (14°F) with standard charging speed.

StoreDot-extreme-fast-charging-EV-batteries
Mullen road tests solid-state polymer battery pack

The initial test results met or exceeded all requirements targeted for the first drive cycles for energy usage and driving range.

Mullen-battery-pack-testing
Zeta Energy awarded a grant to commercialize battery technology

The VTO program was created to accelerate the development of mobility solutions that extend EV range while alleviating supply chain concerns.

ZETA-EV-Charging-Infrastructure-Farmers-Act-1400